Let there be light!

News and General

Story and photos by Richard Soult, www.4x4explorer.co.nz

I have to admit that the idea for this hack came from a guy called Aaron who I met on a recent trip up at the Macaulay Hut.

The initial idea was to take flexible LED strips and attach them to the rear of the truck to provide lighting for the cooking and food preparation area. I went to a couple of automotive and marine suppliers and found that they only sold LEDs in strips of up to about one metre and were relatively expensive. However, the local DIY shop had five metre rolls, complete with switch and joint connector, for around $50. So that’s what I went for.

I bought a roll and set about cutting and soldering it all together to fit the truck. It’s a bit fiddly but really pretty simple with the aid of some YouTube tutorials. All the joints were soldered and heat-shrink wrapped to avoid them coming loose over rough ground, then the lights were wired into the rear roof light.

Having completed this and being very happy with the result, I decided that I was going to fabricate a light bar for the side of the truck for use when the table is up and the awning extended.

For this, I bought an aluminium extrusion for about $70 from an electrical supplier and another roll of LEDs. I drilled a hole in the rear of the extrusion and fed the wire through the rear window and to the same light as the others, using the switch that they came with so that I can either have all lights on or exclude the side light bar.

I found that there wasn’t enough room in the extrusion for bolt fittings and the LED strip, so I attached the unit to the roof rack with cable ties. This seems to have been successful so far.

All in all, very happy with this Hack which took me a couple of hours and cost under $200.

If you enjoyed reading this article and want to use your 4WD to get out there and 4X4Explore some amazing places, subscribe to 4x4Explorer on the link below. There is everything from scenic tarmac roads to remote High Country routes. Every route comes complete with downloadable GPX files, detailed route notes, grades and high quality photos.

Take the effort out of route planning, 4x4Explorer has done it all for you!!!! 

Click here for 4x4 Explorer

 

To read the full story in the October 2018 issue of NZ4WD go to Zinio.com (September 14) or purchase your own hard copy at the Adrenalin store.

 

Publishing Information
Magazine Issue:
Page Number:
16
Contact Us
NZ4WD covers a range of topics of interest to the 4WD vehicle buyer & driver. We're dedicated to providing a wide range of information covering vehicle selection, accessories & upgrading, 4WD clubs & sport, adventure & track stories an

Related Articles
Land Rover Classic launches Classic Defender V8 Soft Top
Land Rover Classic has confirmed the return of an icon with the launch of the Classic Defender V8 Works Bespoke Soft Top – the most desirable classic Land Rover Defender. Soft-top examples of the...
JAC T9 smashes 24-hour endurance record
The JAC (“Jack”) T9's position as a reliable workhorse for Kiwi tradies has been further reinforced by the remarkable achievement of its South African stablemate, which recently shattered the country...
GeoffZone - New 4WD!
I just stepped into the cockpit of possibly the most expensive and capable 4WD in New Zealand! The invitation didn’t, unfortunately, extend to the driver’s seat. But that was to be expected. This was...